Difference between revisions of "I have a problem with Calls"
From Kolmisoft Wiki
Jump to navigationJump to search
| Line 7: | Line 7: | ||
* [[Call is going but not visible in Active Calls]] | * [[Call is going but not visible in Active Calls]] | ||
* [[I do not want to hear an error message at the end of the call]] | * [[I do not want to hear an error message at the end of the call]] | ||
* [[Call hangs after 1 second]] | |||
* [[Call hangs after 8 seconds]] | * [[Call hangs after 8 seconds]] | ||
* [[Call hangs after 30 seconds]] | * [[Call hangs after 30 seconds]] | ||
Revision as of 09:25, 17 November 2015
What problem do you have?
- I cannot make a call
- Call is not going through and not shown in Last Calls
- Call was billed incorrectly
- Call is going but not visible in Active Calls
- I do not want to hear an error message at the end of the call
- Call hangs after 1 second
- Call hangs after 8 seconds
- Call hangs after 30 seconds
- Call hangs after 30 minutes
- Call hangs after 2 hours
- I have a problem with Active Calls
- I have Unlimited Minutes when trying to dial out
- I hear wrong Time for the call
- I do not hear RINGING
- DID is not working
- Calls using ZAP/DAHDI are not working
- Why call was not routed through other provider/trunk?
- Very long delay before ring tone
- Provider is not working
- How to increase call volume?
- Call time in GUI
- Reseller cannot make calls using his providers
- Call does not end when pressing ##
- Digits are skipped when entering destination or PIN
- I have bad Voice quality
- Reseller calls are not working
- Clients want to dial and use local area numbers
- "sip show peers" shows incorrect call limit
- H.323 incoming calls do not work
- H.323 outgoing calls delays
- Call with video support enabled fails
- Somebody is calling over my system!
- username mismatch error in Asterisk CLI
- Spy from Active Calls always connects same call
- Call rejected, CallToken Support required.
- Cannot make calls from FreePBX
- Balance, Calls and Invoices are zero
- Lots of dropped calls
- Calls of NEC PBX are propped after few seconds
- User gets "403 Forbidden" from MOR
- Low ASR/ACD
