Softswitch performance

Single server performance

Performance results in the following conditions (recommended hardware is used, SIP protocol, no transcoding, CPS is low (<5), GUI/DB on another server, other processes than calls are not in use) are:

• MOR - 500 concurrent calls*
• M2 - 1000 concurrent calls*

'* We cannot guarantee such amount of concurrent calls, many factors influence it, such as:

1. CPU
2. RAM
3. HDD type (HDD 5400/7200 rpm, SSD, SAS, raid, etc)
4. Network (routers/switches)
5. Providers (connectivity quality, PDD)
6. Transcoding on/off?
7. Codec used
8. Protocol conversion
9. CPS
10. DB on same server?
11. GUI on same server?
12. GUI/DB load with raports
13. Calling Card calls?
14. Callback calls?
15. Call Center calls?
16. Proxy present?
17. and others

Multi-server performance

If you need better performance than single server solution can offer, you should use multi-server implementations.

Factors which determine call performance

Call capacity vary depending on the following factors:

• Hardware specifications
• Structure of call (you will get 8 times better performance if you send just the signalling without media through the softswitch)
• Processes, running on the same time (if you generate invoices, statistics or run other processes, softswitch performance decreases)
• Additional functionality usage (if you record calls, use different IVR structures, softswitch performance decreases)
• Transcoding (if you do transcoding, performance decreases two times)
• Calls length (if you accept a lot of short calls at the same time (so called dialer or call center traffic), softswitch performance decreases)

See also

• Recommended hardware
• Results of MOR stress tests
• Results of M2 stress tests