Difference between revisions of "How to find out servers IP address"
From Kolmisoft Wiki
Jump to navigationJump to search
| Line 10: | Line 10: | ||
eth0 Link encap:Ethernet HWaddr 00:0C:29:B6:C1:CA | eth0 Link encap:Ethernet HWaddr 00:0C:29:B6:C1:CA | ||
'''inet addr''':<u><b><big>192.168.0. | '''inet addr''':<u><b><big>192.168.0.128</big></b></u> Bcast:192.168.0.255 Mask:255.255.255.0 | ||
inet6 addr: fe80::20c:29ff:feb6:c1ca/64 Scope:Link | inet6 addr: fe80::20c:29ff:feb6:c1ca/64 Scope:Link | ||
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 | UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 | ||
Revision as of 11:07, 8 September 2009
Standard way
Switch on your servers monitor and log in by using root as username and the password you have entered during MOR install.
When you are in, type:
ifconfig
You will see similiar output like this:
eth0 Link encap:Ethernet HWaddr 00:0C:29:B6:C1:CA
inet addr:192.168.0.128 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::20c:29ff:feb6:c1ca/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:43138 errors:0 dropped:0 overruns:0 frame:0
TX packets:31569 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:5289630 (5.0 MiB) TX bytes:18930485 (18.0 MiB)
Interrupt:67 Base address:0x2000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:14987 errors:0 dropped:0 overruns:0 frame:0
TX packets:14987 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:7123869 (6.7 MiB) TX bytes:7123869 (6.7 MiB)
The numbers going after inet addr is your IP address, remember 127.0.0.1 is not your real ip address!
Easy way
Login to server through ssh and enter:
net_info
Remember ticketID and contact Kolmisoft for more info.
