M4 Termination Points

Description

Termination Point is connection to some final entity (device/line/trunk/provider/supplier/etc) where call will be terminated.

Call comes from Origination Points and goes to Termination Point.

Termination Points are assigned to Dial Peers.

Termination Point Settings

Act as Termination Point - turns on/turns of Termination Point. If selected No and saved, all settings of Termination Point will be erased.
Active - activates/deactivates Termination Point.
Tech. Prefix - technical prefix that is added to destination number when dialing through this termination point. Tech prefix can also be used to modify outgoing number by using Tech Prefix rules
Tariff
Capacity - limits the number of concurrent calls to this termination point.
Source (CallerID) Allow - regular expression (regexp) for CallerIDs that are allowed to go through this termination point (use regexp .* if you want to allow all CallerIDs to go through this termination point).
Source (CallerID) Deny - regular expression (regexp) for CallerIDs that are NOT allowed to go through this termination point (leave empty if you do not want to disallow any CallerIDs).
Register - should we register the provider?
Login/Username - username if your provider asks for it.
Password - password used for authentication by your provider.

Advanced

Interpret NO ANSWER as FAILED - This setting set NO ANSWER calls interpretation as FAILED.
Interpret BUSY as FAILED - This setting set BUSY calls interpretation as FAILED

See also

• M2 Disconect Code Changes
• NO_ANSWER/BUSY_interpretation_for_providers