Difference between revisions of "Server is overloaded"
| Line 31: | Line 31: | ||
<br><br> | <br><br> | ||
Here you can set parameters which defines when Server is overloaded. Those [[Configuration_from_GUI#Server_load | Settings]] will be applied to GUI and Database [[Multi Server support|Servers]]. | Here you can set parameters which defines when Server is overloaded. Those [[Configuration_from_GUI#Server_load | Settings]] will be applied to GUI and Database [[Multi Server support|Servers]]. | ||
<br><br> | |||
You can check your server load statistics here: http://IP/billing/stats/server_load/1 (where IP is your GUI IP) and adjust your system's '''Server load''' accordingly. | |||
<br> | |||
That is, check what is the average load of your system and set the '''Server load''' settings a little bit higher (e.g. if the average HDD load is around 40%, set '''HDD utilisation higher than:''' 45% ). | |||
<br> | <br> | ||
This way you will be notified if something goes wrong and server loads are higher than the average. | |||
<br><br> | |||
<br> | |||
Set 0 if you want to disable checking. ('''STRONGLY NOT ADVISED!''') | Set 0 if you want to disable checking. ('''STRONGLY NOT ADVISED!''') | ||
Revision as of 11:16, 3 October 2013
Description
MOR constanty monitors it's servers for various performance stats:
- Hard disk IO
- CPU
MOR according to the complexity of the task may sometimes not allow you to do some tasks during high workloads with this message for admin:
System overload prevented! Please try later or consider upgrading your server hardware.
and this message for other users:
Functionality temporary suspended. Please try again in 5 minutes.
This means that your server(-s) are busy and you should retry the tasks later.
Protection against high loads is implemented in all statistics pages.
Configuration
Go to SETTINGS –> Setup –> Settings
Click on Server load tab and you will see settings:
Here you can set parameters which defines when Server is overloaded. Those Settings will be applied to GUI and Database Servers.
You can check your server load statistics here: http://IP/billing/stats/server_load/1 (where IP is your GUI IP) and adjust your system's Server load accordingly.
That is, check what is the average load of your system and set the Server load settings a little bit higher (e.g. if the average HDD load is around 40%, set HDD utilisation higher than: 45% ).
This way you will be notified if something goes wrong and server loads are higher than the average.
Set 0 if you want to disable checking. (STRONGLY NOT ADVISED!)
MY SERVER IS BLOCKED! NOTHING WORKS! SERVER IS OVERLOADED!
- Please calm down everything is OK, MOR just protected your server from crashing from high GUI/DB usage and saved your business
- Adjust Server Load settings as shown in the picture above
- If it does not help - this means your server is too weak to service your GUI requests, consider moving GUI to separate server
