Zaptel configuration for MOR

From Kolmisoft Wiki
Revision as of 11:36, 12 February 2010 by Mindaugas (talk | contribs)
Jump to navigationJump to search

Checking if Zaptel is installed/configured to work with Asterisk properly

In order to configure Zaptel for MOR, Zaptel should be installed and connected to work with Asterisk properly.

To check that in Asteris CLI issue such command:

CLI> zap show status
Description                              Alarms     IRQ        bpviol     CRC4
wanpipe1 card 0                          OK        0          0          0
wanpipe2 card 1                          OK        0          0          0
wanpipe3 card 2                          OK        0          0          0
wanpipe4 card 3                          OK        0          0          0

Output can be different, but Alarms should show OK.

If you get:

CLI> zap show status
No such command 'zap show' (type 'help' for help)

That means Zaptel is not installed/configured to work with Asterisk properly. Fix it and only after that you can continue in this manual.



Configuring /etc/asterisk/zapata.conf

We as example here will configure each port of ISDN card as separate Provider. For this in /etc/asterisk/zapata.conf file make such changes to context field:

;Sangoma A104 port 1 [slot:1 bus:6 span:1] <wanpipe1>
switchtype=euroisdn
context=from-pstn1
group=0
signalling=pri_cpe
channel =>1-15,17-31
;Sangoma A104 port 2 [slot:1 bus:6 span:2] <wanpipe2>
switchtype=euroisdn
context=from-pstn2
group=0
signalling=pri_cpe
channel =>32-46,48-62
;Sangoma A104 port 3 [slot:1 bus:6 span:3] <wanpipe3>
switchtype=euroisdn
context=from-pstn3
group=0
signalling=pri_cpe
channel =>63-77,79-93
;Sangoma A104 port 4 [slot:1 bus:6 span:4] <wanpipe4>
switchtype=euroisdn
context=from-pstn4
group=0
signalling=pri_cpe
channel =>94-108,110-124