OSLEC installation with DAHDI

From Kolmisoft Wiki
Jump to navigationJump to search


What is OSLEC?

Oslec is an open source high performance line echo canceller. When used with Asterisk it works well on lines where the built-in Zaptel echo canceller fails.
No tweaks like rxgain/txgain or fxotrain are required. Oslec is supplied as GPL licensed C source code and is free as in speech.

More information can be found here

Attention - this manual is addressed to MOR users who are experienced in Linux and Asterisk!

Download and unpack Dahdi

cd /usr/src
wget http://downloads.asterisk.org/pub/telephony/dahdi-linux/dahdi-linux-current.tar.gz
tar xvfz dahdi-linux-current.tar.gz

Download and unpack your Linux kernel sources

At this stage make sure you download the correct kernel sources

Check the current kernel by using command


[root@linux ~]# uname -a
Linux ns205179.ovh.net 2.6.28-grsec-xxxx-grs-ipv6-64 #2 SMP Thu Aug 25 16:40:22 UTC 2011 x86_64 x86_64 x86_64 GNU/Linux

Next, download the kernel sources

wget http://kernel.org/pub/linux/kernel/v2.6/linux-2.6.28.tar.bz2

Unpack

tar xvfz linux-2.6.28.tar.bz2

Prepare the downloaded DAHDI sources to compile with OSLEC included

mkdir /usr/src/dahdi-linux-2.5.0.1/drivers/staging
cp -fR /usr/src/linux-2.6.28/drivers/staging/echo /usr/src/dahdi-linux-2.5.0.1/drivers/staging
sed -i "s|#obj-m += dahdi_echocan_oslec.o|obj-m += dahdi_echocan_oslec.o|" /usr/src/dahdi-   linux-2.5.0.1/drivers/dahdi/Kbuild
sed -i "s|#obj-m += ../staging/echo/|obj-m += ../staging/echo/|" /usr/src/dahdi-linux-2.5.0.1/drivers/dahdi/Kbuild
echo 'obj-m += echo.o' > /usr/src/dahdi-linux-2.5.0.1/drivers/staging/echo/Kbuild

Compile DAHDI and DAHDI tools

cd / usr/src/dahdi-linux-2.4.1.2
make
make install

Download and install DAHDI tools

cd /usr/src
wget http://downloads.asterisk.org/pub/telephony/dahdi-tools/dahdi-tools-current.tar.gz
tar xvfz dahdi-tools-current.tar.gz
cd dahdi-tools-2.4.1
./configure
make
make install
make config

Check the results

After everything has been done, run the following command

updatedb

Check if OSLEC was installed:

oslec locate | grep /lib/ odules

You should see similar output:

/lib/modules/2.6.18-238.9.1.el5/dahdi/dahdi_echocan_oslec.ko

See also

Alternative guide can be found here