Difference between revisions of "How to find out servers IP address"

From Kolmisoft Wiki
Jump to navigationJump to search
Line 2: Line 2:


Switch on your servers monitor and log in by using root as username and the password you have entered during MOR install.
Switch on your servers monitor and log in by using root as username and the password you have entered during MOR install.
When you are in, type:


  ifconfig
  ifconfig

Revision as of 10:16, 8 September 2009

Standard way

Switch on your servers monitor and log in by using root as username and the password you have entered during MOR install.

When you are in, type:

ifconfig

You will see similiar output like this:

eth0      Link encap:Ethernet  HWaddr 00:0C:29:B6:C1:CA
         inet addr:192.168.0.178  Bcast:192.168.0.255  Mask:255.255.255.0
         inet6 addr: fe80::20c:29ff:feb6:c1ca/64 Scope:Link
         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
         RX packets:43138 errors:0 dropped:0 overruns:0 frame:0
         TX packets:31569 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:1000
         RX bytes:5289630 (5.0 MiB)  TX bytes:18930485 (18.0 MiB)
         Interrupt:67 Base address:0x2000
lo        Link encap:Local Loopback
         inet addr:127.0.0.1  Mask:255.0.0.0
         inet6 addr: ::1/128 Scope:Host
         UP LOOPBACK RUNNING  MTU:16436  Metric:1
         RX packets:14987 errors:0 dropped:0 overruns:0 frame:0
         TX packets:14987 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:0
         RX bytes:7123869 (6.7 MiB)  TX bytes:7123869 (6.7 MiB)

The numbers going after inet addr is your IP address, remember 127.0.0.1 is not your real ip address!

Easy way

Login to server through ssh and enter:

net_info

Remember ticketID and contact Kolmisoft for more info.