M2 Hangupcause Codes
From Kolmisoft Wiki
Jump to navigationJump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
Code | Explanation |
300 | Not authenticated (accountcode = 0) |
301 | Originator not found by IP address |
302 | Global Call Limit reached |
303 | Originator Capacity reached |
304 | CPS Limit reached |
305 | Source (CallerID) not accepted by regexp |
306 | Originator Balance Limit reached (Balance Min) |
307 | Originator Rate not found |
308 | Dial Peer not found |
309 | HGC NOT ASSIGNED |
310 | Suitable Terminator not found |
311 | User is blocked |
312 | Caller canceled the call (Freeswitch HGC ORIGINATOR_CANCEL 487) |
313 | User call limit reached |
314 | M2 radius server did not receive accounting start packet (acct start timeout) |
315 | M2 radius server did not receive accounting stop packet (acct stop timeout) |
316 | Freeswitch did not find termination point details |
317 | Registration to termination point failed |
318 | Originator codecs are not allowed |
319 | M2 can not make more calls |
320 | Balance too low to make a call |
321 | Caller's source number (CallerID) does not match terminator's source regexp |
322 | Caller's source number (CallerID) is denied by terminator's source deny regexp |
323 | Terminator's balance limit reached (balance max) |
324 | Rate margin is lower than allowed |
325 | Destination number is in blacklist |
326 | Destination number is not in whitelist |
327 | Terminator's capacity reached |
328 | Terminator's user's call limit reached |
329 | Terminator's CPS limit reached |
330 | Destination is blocked in Originator's Tariff |
331 | Destination is blocked in Terminator's Tariff |
332 | Originator was found by IP but tech prefix does not match |
333 | Originator was found by IP but port does not match |
334 | Source number is in blacklist |
335 | Source number is not in whitelist |
336 | Destination can not be empty |
337 | Call comes from servers which is not assigned to originator |
338 | Unreachable Terminator skipped (Periodic Check is enabled) |
339 | User is not allowed to dial through own terminators |
340 | User's call rate is higher than allowed |
All M2 HGC return SIP 503 by default.
This can be changes in /etc/m2/system.conf using
hgcX = code
Where X is M2 HGC, and code is ITU-T Q.850 Code and then execute command:
m2 reload